Microbe-Lift Oxy Pond Cleaner 8lb.

Oxy Pond Cleaner 8lb.

Oxy Pond Cleaner 8lb.

OXY POND CLEANER will safely yet immediately breakdown accumulated debris from rocks, streams and on waterfalls.

• Uses Oxygen Power to break down unsightly debris
• Especially helpful on streams and waterfalls
• Deep cleans planters and rocks
• Oxidizes and Detoxifies
• Helps to prevent pond odors
• 
  
  Use Weekly to Eliminate Stressful Pond Draining
  
  MICROBE-LIFT/ OPC OXY POND CLEANER will safely spot-treat all areas of light-to-heavy accumulations of debris on rocks, waterfalls, streams, planters, etc. MICROBE-LIFT/ OPC OXY POND CLEANER IS 100% safe when used as directed.
  
  
  DIRECTIONS: MICROBE-LIFT/ OPC OXY POND CLEANER is not temperature sensitive but works best in warmer weather. To achieve the best results, manually clean out as much accumulated debris from the pond as possible and shut down waterfalls before cleaning. Do not dilute. To treat areas with debris build up, sprinkle over areas needing treatment. Make direct contact but avoid live plants where possible.
  
  To maintain a continued proper ecosystem in your pond, always add MICROBE-LIFT/ PL, or any bacterial/enzymatic treatment, 48 hours after using MICROBE-LIFT/ OPC.
  
  DOSAGES: BEFORE USE: Use MICROBE-LIFT/ AMMONIA TEST STRIPS to test for the presence of ammonia in your pond water. If ammonia levels are above 0.8mg/L, DO NOT apply MICROBE-LIFT/ OPC OXY POND CLEANER until the ammonia level is brought down below 0.8mg/L. If ammonia levels exceed 1.0mg/L, add MICROBE-LIFT/ AMMONIA REMOVER.
  
  Spot Treatment: Apply a light application to the area needing to be cleaned.
  
  Large Ponds & Lakes: Apply around perimeter of pond/lakes as much as needed.
  
  Pond Cleaning/Non-Painted Surfaces: 6 cups (96oz.) per 1,000 sq. ft. of surface area to be cleaned.
  
  After Use: Ammonia levels should be monitored for two days following applications of ANY/ALL oxygen release compounds as they can kill beneficial bacteria in a pond/lake resulting in an ammonia or nitrite spike. Use MICROBE-LIFT/ AMMONIA TEST STRIPS to test for the presence of ammonia. If your ammonia levels exceed 1.0mg/L., add MICROBE-LIFT/AMMONIA REMOVER to reduce the ammonia level to 0.8mg/L or below.